We all know that the injection molding machine will have more or less individual problems in the process of injection molding. These problems will certainly cause some damage to the injection molding machine in operation. Below, high-speed thin-wall injection molding machine and everyone to talk about the emergence of injection molding machine in the injection process, the emergence of bubble phenomenon and what?

According to the causes of bubbles, we have the following solutions:

1. When the wall thickness of an injection molding machine is large, the outer surface of the product cools faster than the center, so when the injection molding machine cools down, the plastic resin in the center expands toward the surface while shrinking. This leads to insufficient filling of the center. In this case, the vacuum bubble solution will be called:

a. We will determine the gate size and runner size of the injection molding machine based on the thickness of the thin wall.

b. Up to the gate seal, make sure to have additional injection material.

c. The injection time should be longer than the gate seal time.

d. Reduce the injection speed and increase the injection pressure.

e. Use a material with a high melt viscosity rating. The

2. Because the product itself has a gas bubble caused by the volatile gas, we mainly solve the following methods:

a. Fully dry.

b. In order to avoid decomposition gas generated during the injection molding process, the resin temperature needs to be lowered.

3. Bubbles caused by poor fluidity can be solved by increasing the temperature of the resin and mold and increasing the injection speed. The

The above content is just a personal view of Xiaobian. If you want to learn more about Guangdong energy-saving injection molding machine, you can consult our hotline: 13326865879, or log on our official website: http://www.gdruibao.com/